TOPCON 3D-MC² GRADER
FINISH SUB LAYER
Finish Grade at Significantly Higher Speeds & Tighter Tolerances!

How It Works
3D-MC² utilizes Topcon’s GX-60 control box, GPS+ antenna, MCR3 GPS+ receiver and new 3D-MC² sensor and pairs them with our latest advanced software to provide cutting edge position updates up to 100 times per second. The 3D-MC² sensor combines a gyro, compass and inertial sensor to measure the X (front to back), Y (side-to-side) & Z (up & down) position of the cutting edge as well as the roll, pitch, yaw and acceleration of the motorgrader. Result? Unmatched speed, accuracy and flexibility.
3D-MC² utilizes Topcon’s GX-60 control box, GPS+ antenna, MCR3 GPS+ receiver and new 3D-MC² sensor and pairs them with our latest advanced software to provide cutting edge position updates up to 100 times per second. The 3D-MC² sensor combines a gyro, compass and inertial sensor to measure the X (front to back), Y (side-to-side) & Z (up & down) position of the cutting edge as well as the roll, pitch, yaw and acceleration of the motorgrader. Result? Unmatched speed, accuracy and flexibility.

Complete System Compatibility
As is the case with most of our technologies Topcon’s 3D-MC² is compatible with all of our existing sensor technologies. No matter if you want to use single or twin antennae GPS, patented Millimeter GPS or a robotic LPS solution, all work hand in hand with 3D-MC². You can even use 3D-MC² in a 2D application with Sonic Tracker and/or a laser when GPS or 3D models are not available. Best of all 3D-MC² is just as easy to install on a new grader as it is to add to those with an existing Topcon GX-60 system. Simply mount the 3D-MC² sensor, update the OAF’s and software and calibrate - you are up and running in no time at all.
As is the case with most of our technologies Topcon’s 3D-MC² is compatible with all of our existing sensor technologies. No matter if you want to use single or twin antennae GPS, patented Millimeter GPS or a robotic LPS solution, all work hand in hand with 3D-MC². You can even use 3D-MC² in a 2D application with Sonic Tracker and/or a laser when GPS or 3D models are not available. Best of all 3D-MC² is just as easy to install on a new grader as it is to add to those with an existing Topcon GX-60 system. Simply mount the 3D-MC² sensor, update the OAF’s and software and calibrate - you are up and running in no time at all.